渣浆泵的维修护理包括以下几个方面 ：

1. 轴承水压、水量要满足规定，随时调整（或更换）填料的松紧程度，切勿造成轴封漏浆。并及时更换轴套。

2. 更换轴承时，一定要保证轴承组件内无尘，润滑油清洁，泵运行时轴承温度一般以不超过60-65℃为宜，最高不超过75℃。

3. 要保证电机与泵的同轴度，保证联轴器中弹性垫完整正确，损坏后应及时更换。

4. 保证泵组件和管路系统安装正确，牢固可靠。

5. 渣浆泵的部分部件属于易损件，在日常使用中要关注易损件的损耗情况，及时对其进行维修或更换。渣浆泵易损件维修或更换的过程中要保证装配正确，间隙调整合理，避免紧涩磨擦现象的出现。

The maintenance and care of the slurry pump includes the following aspects:

1. The water pressure and volume of the bearing should meet the regulations, and the tightness of the packing should be adjusted (or replaced) at any time to avoid leakage of the shaft seal. And timely replace the shaft sleeve.

When replacing bearings, it is necessary to ensure that there is no dust and the lubricating oil inside the bearing components is clean. When the pump is running, the bearing temperature should generally not exceed 60-65 ℃, and the maximum temperature should not exceed 75 ℃.

3. It is necessary to ensure the coaxiality between the motor and pump, ensure that the elastic pad in the coupling is complete and correct, and replace it promptly after damage.

4. Ensure that the pump components and pipeline system are installed correctly, firmly, and reliably.

5. Some components of the slurry pump belong to vulnerable parts, and attention should be paid to the wear and tear of vulnerable parts in daily use, and they should be repaired or replaced in a timely manner. During the process of repairing or replacing vulnerable parts of the slurry pump, it is necessary to ensure correct assembly, reasonable gap adjustment, and avoid the occurrence of tight friction.